PWM to Voltage Converter Module PWM 0-100 Working Voltage 12-30V Output Voltage 0-10V Frequency 1KHZ-3KHZ [Syalis]

SYALIS ELECTRICAL STORE
=======================

Introduction:
VCC: Working power 12V-30V.
GND: Working power source.
PWM: The front end of the input PWM signal.
GND: Negative end of input signal.
VOUT: Output voltage 0-10V.
GND: Output voltage ground.

Operation instructions:
– After power-on, when there is no input signal, the output is 0V, and only when there is input can the output be obtained. When the first power is on, it is better to do a calibration debugging: find a 50% duty cycle signal to connect to PWM,GND, the corresponding amplitude of the jump needle. Frequency is 1KHZ-3KHZ. Measure VOUT and GND ports with multimeter. The meter is displayed at about 5V. The potentiometer on the adjusting board is displayed at 5.00V. This calibrates the corresponding relationship between your pulse signal and this module. When the frequency changes, the corresponding relationship may be offset and need to be recalibrated.

– The output voltage can be adjusted by adjusting duty cycle.

– Accuracy can be controlled by adjusting potentiometers

=======================

– Kami menjual berbagai macam kebutuhan electronik
– Segmentasi Display dan Chip
– Butuh Jumlah banyak bisa japri aja gan
– Butuh barang impor lain bisa PO

*Selama katalog tayang stok masih ready sesuai jumlah *Jgn lupa video unboxing untuk klaim bila ada kendala